Taking Care Of Sacramento Contact Lenses

By Nancy Gardner


Contact lenses require the wearer to obtain a prescription outlining the type to purchase even if they are not meant for correction of vision. During physical examination of the eyes, the optician checks for astigmatism, hyper myopia, myopia and general eye health. Your visual strength will also be tested before prescription of Sacramento contact lenses.

In the process of their insertion, the first step should always be washing of hands. They should be adequately dried after that. Then, with your dominant hand, hold the tip of the lens with your index finger and bring down the lower eyelid.

The pointer finger is also used to elevate the lid at the top besides holding lenses. You should look up at this point and place the lens in a gentle manner on the lower side of the sclera. The pointer finger is then removed and the lid released. After doing this, the eye should be closed for a moment to give a chance for the lens to be centered.

The process of taking them off starts with washing the hands too. They should be thoroughly dried thereafter. You should then look up and pull down the lower lid using the middle finger of the dominant hand. The index finger is then used to access the lenses on the lower part. It is then slid down the sclera and squeezed between the thumb and pointer finger. Be careful during the removal process.

The disposable kind of contact lens is meant to be worn only one time. They eliminate the hassle of repeated cleaning and storing. However, caring for lens is not so difficult. Just make sure you adhere to the instructions of your optician. There are commercially made solutions meant to remove proteins, clean, rinse and disinfect the lenses before they are stored.

For comfortable and healthy contact lens wear, they have to get cared for on a daily basis. The procedure involves placing commercial cleaner drops on each on the lenses sides and rubbing gently for about twenty seconds. This is followed by thorough rinsing for about five minutes with a rinsing solution prepared commercially

After the rinsing, they should be put inside a lens case and soaked using a cleansing solution for around 4 hours. The solution used for soaking should always be fresh and discarded immediately after use. After this, you can confidently put on lenses. If there is debris on the lenses surface, they can be done away with using a rinsing solution before being worn.

If they are not in use, they must be kept in specially made cases for safety purposes. They should never be soaked in a saline solution. This does not result to disinfection. The cases may remain closed for a period of thirty days if they are not in use. However, beyond this, they have to be cleaned and disinfected before insertion. The solutions used should be professionally prepared. Otherwise, using something else will not be effective in accomplishing the purpose. Also, the results will be compromised in case the solution is been reused. The case the lens are stored in should be changed on a monthly basis.




About the Author:



0 comments:

Enregistrer un commentaire